If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
rolling mill questions
[[moderator edited, from email apparently intended at least in part (thus the
editing) for the group...]] Interesting how the use of the word "Pallion" has different uses. Yes I know the normal use in our trade is to describe little pieces of solder BUT here the other meaning is the little pieces of gold or silver that are used under clear enamel on watch faces and jewellery as decoraton. these are about 1/10th mm thick and are stamped in relief in red ,yellow and green gold as well as fine silver. Bayeler has supplied me in the past with all sorts of designs , last time in 1978. but particularly the zodiac 12 and others like the French fleur de lys. Lovely to use too. Ive 2 catalogues of theirs witlh pictures of all the designs they make and the no run to over 1500. their address and Ph no is Bayeler & Cie .S.A. Fabrique de Cadrans 2-4 rue des deux-ponts 1211 Geneva 8 Switzerland Tel. 0041 022 24 62 40 Just on the off chance you know of an agent in the usa. youd enjoy using them. So simple to use. once youve enamelled the work piece you just stick the paillion ontop of the enamel with a tiny bit of spittle, Yes!! its fine, using a tiny paint brush to pick it up and place it. then re fire it and it settles onto the enamel all by itself. no oxidation . then you put a tiny dusting of cleat or clear coloured enamel on top , re fire asnd its done. looks great. Ted |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rolling Mill | Kendall Davies | Jewelry | 13 | July 17th 12 06:07 PM |
rolling mill questions | br | Jewelry | 30 | September 23rd 06 09:45 PM |
I just picked up a ROLLING MILL , now I have some questions ! | mtnrabbit | Jewelry | 3 | November 9th 05 09:02 AM |
Slitting machine, Slitting, Rolling mill, Wire Flattening Mill, Sheet Leveler, Section Leveler, Scalping Machine, Brush Machine, coiler, decoiler, recoiler, 4 Hi, 6 Hi, 4 High, 6 High, Rolling mill, Wire Flattening Mill, Polishing Machine, Rewinding | korak | Marketplace | 0 | December 14th 03 05:52 PM |
Slitting machine, Slitting, Rolling mill, Wire Flattening Mill, Sheet Leveler, Section Leveler, Scalping Machine, Brush Machine, coiler, decoiler, recoiler, 4 Hi, 6 Hi, 4 High, 6 High, Rolling mill, Wire Flattening Mill, Polishing Machine, Rewinding | korak | Quilting | 0 | December 14th 03 05:52 PM |