If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rolling mill success!
Thanks to all who offered useful suggestions. I am getting the rolling mill
I wanted in a few days. Finally, I got through to him!! chris |
Ads |
#2
|
|||
|
|||
Just out of curiosity, what worked?
|
#3
|
|||
|
|||
I'm pretty sure it was just the accumulation of the past several years
complaining about not having one. chris "NE333RO" wrote in message ... Just out of curiosity, what worked? |
#4
|
|||
|
|||
"HoyoD" wrote in message ... I'm pretty sure it was just the accumulation of the past several years complaining about not having one. So you bit your lip and kicked him in the shin, and that bony bit that sticks out too? Nice one. -SP- chris "NE333RO" wrote in message ... Just out of curiosity, what worked? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ingenius Success | Alvin | Doll Houses | 0 | January 13th 05 02:56 PM |
best size to mill basswood for carvers | Bruce H | Carving | 3 | September 10th 04 09:30 PM |
Mill Hill gold beads - durability? | mªdcªt | Beads | 2 | November 30th 03 04:02 AM |
About rolling mills..... | HoyoD | Jewelry | 28 | November 6th 03 10:02 AM |
Was "About rolling mills". Now, group standards. | Peter W. Rowe | Jewelry | 0 | November 2nd 03 11:08 PM |