If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
How to remove plastic/rubber liner from bottle caps?
If anyone has an idea I would offer you my firstborn for it (ok, so
there is no firstborn) I am seriously stuck on this one. I have tried boiling them and also using acetone nail polish remover (both ideas I found on the internet). If the bottle caps have a thin round rubber ring I can boil them and then pull them off. However, if the lining covers the whole inside of the bottle cap I can't get it off - basically I keep trying to rip at it and get nowhere fast. Please help!!!! Thanks, Laurianne |
#2
|
|||
|
|||
How to remove plastic/rubber liner from bottle caps?
I don't know how to clean them but you can get blank ones that are
already clean here, close to the bottom of the page: http://www.outsidethemargins.com/dollarama.html Ingrid http://www.mermaidscove.com |
#3
|
|||
|
|||
How to remove plastic/rubber liner from bottle caps?
Laurianne -- I'm not even slightly intriqued; just nosy. Why? Becki |
#4
|
|||
|
|||
How to remove plastic/rubber liner from bottle caps?
LOL Me too - I am really curious.
-- Kandice Seeber www.lampwork.net Vote for my site! http://tinyurl.com/bbcon "Beckibead" wrote in message oups.com... Laurianne -- I'm not even slightly intriqued; just nosy. Why? Becki |
#5
|
|||
|
|||
How to remove plastic/rubber liner from bottle caps?
I am using them for jewelry creations and am finding that if I leave
the "ring" on them that it shows through the back of my picture/sticker etc. once I pour on the resin. They look much better with the plain bottle cap. Thanks! |
#6
|
|||
|
|||
How to remove plastic/rubber liner from bottle caps?
Oh, cool!
-- Kandice Seeber www.lampwork.net Vote for my site! http://tinyurl.com/bbcon wrote in message ups.com... I am using them for jewelry creations and am finding that if I leave the "ring" on them that it shows through the back of my picture/sticker etc. once I pour on the resin. They look much better with the plain bottle cap. Thanks! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
I belted my kid (ON topic) | Kathy N-V | Beads | 4 | August 6th 05 08:17 AM |