If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
New to Group
Merry Christmas one and All.
I live in a little town in northern Ca. Burney. Trying to open a shop. I wanted it to be my pottery studio- the community wanted a ceramic shop instead with instruction. This is not my fortae but I quess I am learning by the seat of my pants LOL. I have a 12 sided kiln about 3 feet tall with two sections I cant run bothe halfs because it kicks by breaker and even if I fire it for 16 hrs it still does not get to cone 04-05 but the peices seem to be just fine even the glazed ones. Any and all sugestion are welcome Saralan |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
new group proposed for vision impairments | Aula | Beads | 0 | June 19th 06 11:19 AM |
new group proposed for vision impairments | Aula | Needlework | 0 | June 19th 06 11:19 AM |
Quilting Group | Marcella Peek | Quilting | 14 | June 15th 06 05:37 AM |
A lesson in Posting to this group: | Fred | Needlework | 15 | October 27th 04 12:15 AM |
Catalog recyclers beware! END OF THREAD | Peter W. Rowe | Jewelry | 10 | December 3rd 03 08:44 AM |