If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bending trimboard or moulding
I have several archways in my dollhouse that require a curved
trimboard or moulding. There is at least one manufacturer that makes a curved arch, but it doesn't fit all of my arche...and they're not cheap. Does anyone know if there is a way to bend moulding to fit an archway? |
Ads |
#2
|
|||
|
|||
For bending wood you have to make it more flexible. You can soak it in
ammonia or hot water and then bend it around a can or cylinder of some sort that has an appropriate diameter to match your arch. Tape/tie it to the cylinder and let it dry. It will basically retain the bend. If it straightens a little too much when you remove it from the form/cylinder, do it again on something with a smaller diameter. Pat "ahash" wrote in message om... I have several archways in my dollhouse that require a curved trimboard or moulding. There is at least one manufacturer that makes a curved arch, but it doesn't fit all of my arche...and they're not cheap. Does anyone know if there is a way to bend moulding to fit an archway? |
#3
|
|||
|
|||
On Thu, 18 Sep 2003 22:52:35 GMT, "PConnelly" wrote:
For bending wood you have to make it more flexible. You can soak it in ammonia or hot water and then bend it around a can or cylinder of some sort that has an appropriate diameter to match your arch. Tape/tie it to the cylinder and let it dry. It will basically retain the bend. If it straightens a little too much when you remove it from the form/cylinder, do it again on something with a smaller diameter. Along with these ideas, you might want to add making some relief cuts on the backside of the molding. If you're going to frame up to the surface of the molding,the cuts will be hidden by the wall. I would make the cuts equal to half the thickness of the molding, and put them as close together as possible. Probably the width of an Exacto razor saw blade and 1/8" apart. Definitely experiment with the ideas, though, before committing your "good stuff" to any given technique. -- Chuck *#:^) chaz3913(AT)yahoo(DOT)com Anti-spam sig: please remove "NO SPAM" from e-mail address to reply. September 11, 2001 - Never Forget -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World! -----== Over 100,000 Newsgroups - 19 Different Servers! =----- |
Thread Tools | |
Display Modes | |
|
|