If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Installing three zone controller on your kiln
Have you tried a kiln vent to even out the temperature, they really do work.
Dave - how does the kiln vent accomplish that? |
Ads |
#12
|
|||
|
|||
Installing three zone controller on your kiln
"Davis Salks" wrote in message ups.com... Have you tried a kiln vent to even out the temperature, they really do work. Dave - how does the kiln vent accomplish that? The kiln vent draws a small amount of air out through the bottom of the kiln through holes in the lid and can correct uneven firings as well a take all the nasty gases out of your kiln room. There are many types, this is the best - lots of info here http://www.ortonceramic.com/pyrometr...FQn4YgoddlXsJg They are not cheap, but cheaper than new elements. I could re-design the elements for you, but you would still have to get someone to make them as I no longer have a winder and I am in Australia anyway. Dave |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Retrofitting your kiln with a 3-zone digital controller | Davis Salks | Pottery | 0 | December 24th 06 11:42 PM |
Important - Please beware of a company called Bohle | Eric Russell | Glass | 2 | August 23rd 04 07:46 PM |
FAQ Raku part 2 of 2 | SBRANFPOTS | Pottery | 0 | October 21st 03 02:13 PM |
FAQ Raku part 2 of 2 | SBRANFPOTS | Pottery | 0 | September 16th 03 11:11 PM |
Raku FAQs | Tom Buck | Pottery | 0 | July 20th 03 04:49 AM |