If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Oxygen cylinder for a mini 'welding' torch?
Not sure where to ask this so thought I'd start here .........
Note: I'm in the UK My father is a jeweller and has had a kind of mini welding torch for some years for doing very fine welding work on jewellery (the torch is a 'Micro-Torch' by Formadent, France). He has though just found out that he can no longer get hold of new oxygen cylinders from his usual supplier. The oxygen cylinders he currently has are labelled: Prodont-Holliger SA 06140 VENCE FRANCE and have a brass screw thread they are 74mm in diameter and 265mm in length I've done a search on the 'net but can't find anything, not even the company referred to. As an alternative, can he get the existing cylinders refilled? The welding torch uses two oxygen cylinders and one gas cylinder (the latter is much smaller than the former and has Miniflam written on it). Any thoughts or ideas please? Ta, Phil To avoid Spam I've not used my real email address in the header, so if replying via email, please send to: phil at morris0 dot fsnet dot co dot uk |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oxygen Concentrator Troubleshooting | Rick Frazier | Beads | 4 | April 27th 16 02:24 AM |
Oxygen Supplies | Samantha BeanHead | Glass | 9 | February 1st 05 03:02 PM |
[Ganoksin] [Issue #103] Tips From The Jeweler's Bench | Ganoksin | Beads | 0 | July 14th 04 01:41 AM |
Oxygen Concentrator Troubleshooting | Rick Frazier | Glass | 3 | September 14th 03 01:58 PM |