If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wheelhead pins
Anyone knows the shimpo or brent wheelhead's pins thread size? is it
1/4-20? Thx |
Ads |
#2
|
|||
|
|||
Wheelhead pins
Shimpo is 1/4 but you have to understand that 1/4 is not all that you need
(I hope my memory is serving me right). The head size varies a bit depending on what you get (stainless steel, brass, etc.). I got various ones and tried them out - some would fit one bat and others another. wrote in message oups.com... Anyone knows the shimpo or brent wheelhead's pins thread size? is it 1/4-20? Thx |
#3
|
|||
|
|||
Wheelhead pins
1/4-20 cap screw.
a friend told me to replace my pins before re-drilling all my bats. the bats were holding loosely on the pin heads. i was STUNNED how that simple change tightened up my bats! the heads wore down A LOT & i hadn't noticed. see ya steve |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pins everywhere! Oh argh!! | Georg | Quilting | 0 | January 9th 06 12:20 PM |
Pins everywhere! Oh argh!! | She in PA | Quilting | 0 | January 9th 06 08:08 AM |
Pins everywhere! Oh argh!! | Kate Dicey | Quilting | 0 | January 9th 06 07:50 AM |
Pins everywhere! Oh argh!! | Taria | Quilting | 3 | January 9th 06 02:38 AM |
Kinds of quilting pins; how to pin; stitch in the ditch machine quilting; fancy designs | Beth Pierce | Quilting | 10 | February 25th 04 10:23 PM |