If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sculpey Ultralight
Oh yeah, I'm loving this stuff! Does anyone know just how thick you
can go with it? I've been using foil for armature building, but the packaging for the Ultralight says it's a good substitute. But they don't say how thick you can go, and how long will it take to cure? I know the general 15 minutes per 1/4 inch rule, but does that mean I can sculpt a piece 4 inches thick and then bake it for 4 hours? Seems a little excessive..... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anything softer than sculpey primo? | Aaron Freeman | Polymer Clay | 2 | November 28th 05 04:03 PM |
Sculpey strength? | Polymer Clay | 13 | August 27th 04 11:40 PM | |
burnt sculpey!!! | Metis Artist | Polymer Clay | 1 | June 25th 04 06:07 PM |
Where to find sculpey in London | anna meier | Polymer Clay | 0 | February 11th 04 04:18 PM |
selling sculpey | glennda | Jewelry | 5 | December 21st 03 09:13 AM |