If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Omni-1` and Omni-2 saws???
Hi all,
anyone got hands on experience with either or both of these saws? my main requirement is cutting very small pieces of Dichroic thks for any advice. my supplier has Omni -1 on sale for $170.00 -- "Poor people have access to the courts in the same sense that Christians had access to the lions." - Judge Earl Johnson Jr. |
Ads |
#2
|
|||
|
|||
somebody must have some experience???
"Boner the Cat" wrote in message m... Hi all, anyone got hands on experience with either or both of these saws? my main requirement is cutting very small pieces of Dichroic thks for any advice. my supplier has Omni -1 on sale for $170.00 -- "Poor people have access to the courts in the same sense that Christians had access to the lions." - Judge Earl Johnson Jr. |
#3
|
|||
|
|||
I have an Omni-2, but I have just started doing stained glass work. I tested
it out on some plate glass when I first got it, and it seemed a little wobbly on the cut. I'm going to be switching to using distilled water because there was a lot of foaming from the cooling spray - wish I could give you any more information. "Boner the Cat" wrote in message om... somebody must have some experience??? "Boner the Cat" wrote in message m... Hi all, anyone got hands on experience with either or both of these saws? my main requirement is cutting very small pieces of Dichroic thks for any advice. my supplier has Omni -1 on sale for $170.00 -- "Poor people have access to the courts in the same sense that Christians had access to the lions." - Judge Earl Johnson Jr. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Omni Stick | bambam | Doll Houses | 1 | October 1st 03 01:18 AM |