If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3d design software for tiffany lamps
Anyone here that uses computer software for designing tiffany lamps in
3D perspective? I'm not talking about lamps with flat panels, because I can use Dragonfly's Glass Eye for that. I'm talking about the more spherical (half ball) shaped lamps. I'd like to design a lamp in 3D and them map the design to a 2D printout that I can use to cut the glass pieces in their actual size size. I'm guessing some CAD software can help me with this task, but I don't know where to look and what to look for. Any suggestions? \Bart |
Ads |
#2
|
|||
|
|||
3d design software for tiffany lamps
Bart wrote:
Anyone here that uses computer software for designing tiffany lamps in 3D perspective? ****************** No software that I know of. You could improvise with a standard CAD package like Solid Edge, but the overhead might make doing it by hand a more viable option. Doing it in CAD, I would take measurements on a standardly available Worden or Odyssey form and duplicate it in software, and then draw your design on it. Then section it off to reduce deformation caused by converting a curved surface to flat, and then do tangential and scaled screen shots (bitmaps) of your model. Print them out and transfer them to the form. If you used a Worden mold, it will already be sectioned and you can follow that. As far as using an Odyssey form, I have heard of temporarily gluing architectural linen to it, but I am clueless as to the details. Good luck, Michael |
#3
|
|||
|
|||
3d design software for tiffany lamps
Michael wrote:
Bart wrote: Anyone here that uses computer software for designing tiffany lamps in 3D perspective? ****************** No software that I know of. You could improvise with a standard CAD package like Solid Edge, but the overhead might make doing it by hand a more viable option. Doing it in CAD, I would take measurements on a standardly available Worden or Odyssey form and duplicate it in software, and then draw your design on it. Then section it off to reduce deformation caused by converting a curved surface to flat, and then do tangential and scaled screen shots (bitmaps) of your model. Print them out and transfer them to the form. If you used a Worden mold, it will already be sectioned and you can follow that. As far as using an Odyssey form, I have heard of temporarily gluing architectural linen to it, but I am clueless as to the details. Good luck, Michael I do not work with cols glass, so I have no experience for tiffany work. Fos some other strange designs I have abused boat design software called Freeship. The you gan define edges rounded or sharp and if surfaces are defined developable, it keps them more or less flat. -lauri |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hello This letter is to solicit your business to sell our line of Tiffany lamps and window panels | pamela | Glass | 3 | April 28th 07 08:34 AM |
Bead design software | Su | Beads | 1 | September 22nd 06 03:45 AM |
Jewelry design Software | T.E.L. | General Crafting | 0 | May 5th 06 07:34 PM |
Design software | Addie Otto | Needlework | 2 | January 8th 06 11:38 AM |
Free Embroidery Design Software Cracks | News | Needlework | 2 | December 9th 04 12:46 PM |