If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Does the Shimpo RK-10 Super have Cone Drive or Belt Drive
I realize this post is almost 20 years old... wow... but I am currently desperately seeking a drive ring for a Shimpo RK-8. Does anyone have a lead on this? Thanks in advance for any help!!
On Tuesday, August 4, 1998 at 3:00:00 AM UTC-4, D. & N. Harvey wrote: Alan wrote: I am purchasing a new potters wheel, and I am trying to decide what model to buy. I was told by my pottery instructor, who has been teaching for over 25 years, that the he has found the cone drive Shimpo wheels to be the most reliable. I asked two different suppliers if the RK-10 Super was cone drive. One supplier said "I fix them all the time, Shimpo hasn't made cone drive wheels in years." The other supplier said "I fix them all the time, I am sure that they are still manufactured with cone drives." Who is right? I understand that Shimpo also has a master series, which is belt drive. Since the suppliers are out of town, I can't open up the wheel and see for myself. the cone drive is the deal ..mines at least 25 years old.. you can tune them up yourself and the action is much better than a beltdrive. D.Harvey |
Ads |
#2
|
|||
|
|||
Does the Shimpo RK-10 Super have Cone Drive or Belt Drive
Have you tried contacting Shimpo? I have had very helpful responses from Shimpo in Japan regarding parts for old wheels - they supplied a drive ring for an RK2 and a foot pedal control cable for an RK 10. Plus, for the RK 2 I found that some of the rubber mountings used on the later RK 10 are almost identical (Shimpo claim the rubber mountings for the RK 2 are discontinued) I rebuilt my RK 2 using replacement mountings and a new drive ring and it's as sweet as a nut now.
Try searching for a parts list on the Shimpo support web site. If you can quote a part number to Shimpo that will greatly help them support you. Regarding cone drive: the RK2 uses cone drive from motor an intermediate wheel, which then uses a belt to drive the wheel head. The RK 10 (AKA RK 21) uses a "metallic traction drive" attached to the motor, which then drives a similar belt that takes power to the wheel head. The advantage of a cone drive is that the motor is running at full speed all the time, whereas a variable speed motor is running very slowly at low wheel head speeds, so is easier to stop with a heavy clay load. The RK 2 and RK 10 are tough little brutes and should easily overcome your attempts to stop them. Good luck Peter |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ricky Tims Drive-By | Sandy E | Quilting | 8 | October 26th 10 10:41 PM |
Test drive?? | KI Graham | Quilting | 5 | January 30th 08 07:35 PM |
Drive band problems | WoolyGooly | Yarn | 4 | April 27th 07 04:00 AM |
This will drive you nuts -- totally OT | Jere Williams | Needlework | 14 | October 18th 05 01:05 PM |
Hard Drive Failure | ALZ | Quilting | 9 | December 3rd 04 01:56 AM |