If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sculpey strength?
Hi all. I was thinking of making a 3d sculpture that will eventually be
wall mounted. I am currently leaning towards using a oven bake clay such as sculpey. My question is having never used it I am concerned about the strength, in terms of fragility. The piece will not be handled and will be mounted and framed. Also if anyone has any suggestions as to clear coat or clear strengthening agent please feel free to mention them. Thanks. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Knots and rope strength | [email protected] | Knots | 2 | December 20th 04 06:41 AM |
burnt sculpey!!! | Metis Artist | Polymer Clay | 1 | June 25th 04 06:07 PM |
Door Insert Strength | Harold E. Keeney \(Hal\) | Glass | 11 | November 28th 03 09:30 PM |
Blending Premo & Sculpey III | Shannon | Polymer Clay | 1 | November 21st 03 04:48 AM |
Sculpey Eraser Clay - one year later | Irwin | Polymer Clay | 3 | October 21st 03 09:06 PM |