|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 2nd 04, 04:53 AM
|
|||
|
|||
Cabachon saw/grinder/polisher combo recommendations
I'm not too new and have taken a few cab classes at my local club and want
to buy a combo machine for home. I've looked the the Lortone, Covington, and the Barranca 6" Diamond Cab Combo Workshop. The Barranca is the most expensive but comes with all the diamond blade/belts/discs etc.. that I need. I can't find any reviews on the net on it and am hoping some of you more experience folks here might have some suggestions or recommendations. Thanks, D 
|
| Ads |
|
#2
April 3rd 04, 02:43 AM
|
|||
|
|||
|
Have you looked at the Genie?
"DesertFlea" wrote in message ... I'm not too new and have taken a few cab classes at my local club and want to buy a combo machine for home. I've looked the the Lortone, Covington, and the Barranca 6" Diamond Cab Combo Workshop. The Barranca is the most expensive but comes with all the diamond blade/belts/discs etc.. that I need. I can't find any reviews on the net on it and am hoping some of you more experience folks here might have some suggestions or recommendations. Thanks, D
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
