|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
September 20th 04, 09:54 PM
|
|||
|
|||
I have one of those machines around, and I intend to give it a "spin". The
only thing that worries me is that it's pretty heavy. The weight is distributed over the surface area of the brushes so in terms of PSI there's hardly any, you'll be amazed at how black the cames polish up to. - Check my most up to date email address at: www.haruteq.com/contact.htm banjo bridges, tabs, stained glass: www.haruteq.com **may your moments of need be met by moments of compassion** 
|
| Ads |
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Failed copper patina on stained glass | Adrian | Glass | 7 | May 3rd 10 11:54 PM |
| Handmixed Brown Glass Recipe | Kaytee | Beads | 0 | October 29th 04 05:41 AM |
| OT Cheap But Good Recipe was: (sorta?) It's happening again! | Kaytee | Beads | 7 | July 12th 04 10:13 PM |
| OT. Shrewsbury biscuit recipe. | Shirley Shone | Beads | 6 | October 27th 03 05:15 PM |
Linear Mode
