|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 7th 03, 12:10 AM
|
|||
|
|||
crimp tube question
Okay, I messed around with some basemetal crimp tubes and now I want to
order some in SS. I am also ordering Beadalon, .012". What size crimp tubes should I get? When I bought the "play with it" stuff I just followed the Beadalon size recommendations, but these are different. TIA Laura 
|
| Ads |
|
#2
August 7th 03, 01:32 AM
|
|||
|
|||
|
For cable that small, I would go with 1mm tube crimps and micropliers. .14
and up gets 2mm tubes and basic crimping pliers. -- Kandice Seeber Air & Earth Designs http://www.lampwork.net Okay, I messed around with some basemetal crimp tubes and now I want to order some in SS. I am also ordering Beadalon, .012". What size crimp tubes should I get? When I bought the "play with it" stuff I just followed the Beadalon size recommendations, but these are different. TIA Laura
|
|
#3
August 7th 03, 02:54 AM
|
|||
|
|||
|
At any rate, *your* world will never be the same...
Deirdre On Wed, 6 Aug 2003 21:28:28 -0400, "laura" wrote: The world may never be the same! Bwahahahaha 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Posting Question | angela | Beads | 25 | August 7th 03 12:57 PM |
| Flex Shaft question | Karen_AZ | Beads | 13 | August 1st 03 06:44 PM |
| Question for Kandice | BedazzlingJewels | Beads | 5 | August 1st 03 07:05 AM |
| Another question.... Question about Beading Thread | Ken Knecht | Beads | 3 | July 16th 03 06:24 AM |
| Crimping Question | SmartAlecBlonde4 | Beads | 14 | July 7th 03 01:08 AM |
Linear Mode
