If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
needle problem, help needed
I have a standard gauge Brother machine.
I have just fitted a new retaining bar since I was having trouble with needle selection. I now find that I cannot put the needles into holding position without them lifting out of the bed. Have not had this problem before but am hoping it is me, not the machine, that has done something wrong. Sue Derby, England. Don't try to email me using "REPLY" as the email address is NoSpam. Our email address is "thewoodies2 at ntlworld dot com" |
Ads |
#2
|
|||
|
|||
needle problem, help needed
The easiest way to do it is to remove the bar again, then insert it again
slowly as you hold the needles down with a ruler or something . As it goes through, move the ruler along. You'll see them move as the bar goes over the top |
#3
|
|||
|
|||
needle problem, help needed
Thanks for your reply which I found today having thought through and
corrected the problem yesterday. (You were correct...wrong-way-upness was indeed the cause!) -- Sue Derby, England. Don't try to email me using "REPLY" as the email address is NoSpam. Our email address is "thewoodies2 at ntlworld dot com" "David Toft" wrote in message ... In article , Sue writes I have a standard gauge Brother machine. I have just fitted a new retaining bar since I was having trouble with needle selection. I now find that I cannot put the needles into holding position without them lifting out of the bed. Have not had this problem before but am hoping it is me, not the machine, that has done something wrong. Sue Derby, England. The retaining bar goes on top of the needles, not underneath them -- David Toft |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solution to my Pattern Maker problem. | F.James Cripwell | Needlework | 4 | July 21st 05 06:24 PM |
Janome problem | joysjane | Quilting | 8 | September 20th 04 07:30 AM |
Which needle? problem solved | Polly Esther | Quilting | 27 | September 12th 04 04:52 PM |
boyd needle master kit | spampot | Yarn | 0 | April 1st 04 02:52 AM |
Advice needed for foster situation - breeders pls. read | LeeAnne | Quilting | 2 | September 13th 03 12:12 AM |