If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Hi all ,
Been away for a while. I hope some of you electonic potters out there are scribbling and soldering away! If any of you want to share your circuits and ideas my offer of putting up a wwwpage is still good - you can email me at soyaheartreplica@ aol.com (sans spaces) with plans and txt and I'll put up a simple page per design. I'm not to sure about having my kiln controlled by a chopper tho'... that means something else here in UK ... :-) Come on Ian, Don, Bob and James let me know your thoughts please - I want to build something! cheers all R |
Ads |
#12
|
|||
|
|||
"ian" wrote in
. com: Look at www.bartinst.com. I built a single zone controller for a test kiln using one of their controller boards. Was not too hard to do. Hardest part was making the enclosure.Bartlett offers plans at the website. What was your design Ian ? |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Important - Please beware of a company called Bohle | Eric Russell | Glass | 2 | August 23rd 04 07:46 PM |
FAQ Raku part 2 of 2 | SBRANFPOTS | Pottery | 0 | October 21st 03 02:13 PM |
FAQ Raku part 2 of 2 | SBRANFPOTS | Pottery | 0 | September 16th 03 11:11 PM |
Raku FAQs | Tom Buck | Pottery | 0 | July 20th 03 04:49 AM |
FAQ:Intro to rec.crafts.pottery | Mishy Lowe | Pottery | 0 | July 18th 03 06:05 AM |