If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Traditional hand drill
I am interested in using traditional hand tools for jewelry
fabrication. I understand there are several types of hand drills; spiral drill, hand crank drill, and the kind that uses a stick and rope. I have a Dremel and don't want to spend on a flex shaft yet. What is the best bet for a traditional hand drill to drill holes up to, say 1 mm or so? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reamer and DTH hammer, drill tube, drill rod, drill bit, rock bit, | Bin | Glass | 0 | August 28th 06 04:36 AM |
core bit, core barrel,drill bit, drill rod, shank adaptor, extension rod | Bin | Glass | 0 | August 28th 06 04:33 AM |
6 Hand Carved Miniature Korean Figures Traditional Garb | .. | Doll Houses | 1 | May 10th 05 02:02 AM |
Small drill | TRCB | General Crafting | 5 | May 1st 05 08:29 PM |
Drill for rocks | Mick | Carving | 6 | October 8th 04 12:54 PM |