"liam potts" wqdwqe@kjka wrote in message
news
I am looking to build a controller for my kiln its 240 30 amp
it has 4 240 6kw elements in it. I was thinking of using the Omega CN1501
Series http://www.omega.com/ppt/pptsc.asp?ref=CN1501. I am a little
confused
on how many relays an output can control I assume its one for one but I am
not sure. Any advice would be greatly appreciated
Liam Potts
If you want all elements to operate, "as one", all off or all on, then what
I have in mine is one relay per element, but all the relays run on one
controller.
Bet Jack chimes in here any minute, and I certainly would follow his
recommendations, he has done it successfully.