HELP!! Does anyone own a Janome MC 6600p
 

I inherited this beautiful machine when my Mum died 2 years ago and everything was going fine until something happened and I cannot get the presser foot to go to it's lowest extent.

There is a gap of around 2-3mm when the foot lever is in it's lowest position which means that it is not possible to sew at all as there is no engagement with the dog feet.

Does anyone know why this has happened and how I might be able to correct it so I can sew again??

HELP!! Does anyone own a Janome MC 6600p
 

It's in the "Extra Lift" position. If memory serves, if you press the up/down needle position button with the presser foot at the extra lifted position, the LCD
screen should advise you to lower the foot and it should stay there.

If it is anything like my machine it will go to the 'extra lift' position if you lift the presser foot lifter all the way up.

-Irene Scott

On Thursday, July 2, 2020 at 6:38:33 AM UTC-7, wrote:
I inherited this beautiful machine when my Mum died 2 years ago and everything was going fine until something happened and I cannot get the presser foot to go to it's lowest extent.

There is a gap of around 2-3mm when the foot lever is in it's lowest position which means that it is not possible to sew at all as there is no engagement with the dog feet.

Does anyone know why this has happened and how I might be able to correct it so I can sew again??